Istruzioni per la ricarica del refrigerante del congelatore a grande differenza di temperatura
Nello sviluppo dell'industria moderna, il congelatore a grande differenza di temperatura è importante anche per il trattamento del freddo. Nell'intero processo di refrigerazione del congelatore a grande differenza di temperatura, anche la carica del refrigerante è più importante. Come si fa a...
For large-temperature-difference freezer refrigeration systems without high-pressure reservoirs and low-pressure vapor-liquid separators, the control of refrigerant charge is particularly important. Because the refrigeration system is a condenser and also acts as a high-pressure reservoir, the refrigerant is stored in the condenser, and the condenser is cooled. The heat dissipation area is reduced and the condensing pressure is increased, resulting in a decrease in cooling capacity.
For the control of the refrigerant charge of such a large temperature difference freezer, during the charging process, the temperature of the condenser casing should be touched, the upper outlet of the condenser outlet is heated, and the outlet below the outlet is cool (heating) It is indicated that there is a high-temperature exhaust gas of the compressor condensing inside, and the cooling is cold, indicating that the water-cooled large temperature difference refrigerator is a liquid space). Secondly, look at the suction pressure, which corresponds to the temperature of the refrigerant water in the evaporator (that is, corresponds to the evaporation temperature). Then, depending on the return temperature of the compressor of the large temperature difference refrigerator, the return pipe of the high temperature unit should be cooled and dew, but it can be dew condensation to the compressor return valve. The return pipe of the low temperature unit should be frosted, but the frost is compressed. The machine return valve is fine. If condensation or frost builds up on the compressor casing, liquid refrigerant will enter the crankcase, causing the compressor to run oil and liquid. For hermetic compressors, the motor terminals are also shorted. Although most of the closed unit terminals are sealed with a sealant, the possibility of a short circuit still exists due to the uncertainty of the sealing effect.
The above is the refrigerant charging method of Wuxi Guanya LNEYA finishing, hope to help everyone to run a large temperature difference freezer.
Raccomandazioni correlate
-
Ha vinto il "Premio per lo sviluppo di alta qualità 2021".
2483Nel pomeriggio dell'8 maggio 2022, in Hongshan Street, nella città di Wuxi, si è tenuta la conferenza annuale di riepilogo ed elogio del 2020. L'azienda Wuxi Guanya Constant Temperature Refrigeration Technology Co., Ltd. (LNEYA) ha vinto il "Premio per il contributo eccezionale 2020". Ltd. (LNEYA) ha vinto il premio "2020 Outstanding Contribution Award"...
Visualizza dettagli -
What do the LNEYA chiller fault codes mean? What is the solution?
2452Q: What is the fault code of the chiller? Answer: E1 means extremely high indoor temperature alarm, E2 means extremely high temperature alarm, E3 means extremely low temperature alarm, E4 means indoor temperature controller failure, E5 means water...
Visualizza dettagli -
LNEYA precision test thermostat system design instructions
1652The lapping test thermostat is a device that is used to control the temperature of various semiconductors in the chip industry, and its temperature range is controlled to test its performance. Therefore, the lapping test thermostat system can have...
Visualizza dettagli -
Precautions for the replacement of refrigerating oil in the cooling system of the vehicle charger
1592The cooling system of the on-board charger should pay attention to the condition of the refrigerating oil during the operation. After the compressor is started, carefully observe the changes in the oil temperature and oil pressure. If the oil chan...
Visualizza dettagli
Refrigeratori industriali LNEYA Produttore Fornitore










